Installing Hatches
 

Does anybody out there have any experence installing hatches on a kayak? I've read a few articles on the subject but they were more for Boaters cutting into fiberglass. I think the process will be simple enough, cut a hole, place the hatch over the hole and screw down (well nut and bolt acually), apply enough Marine Goop to seal the hatch and viola. Anybody know anthing more?

Re: Installing Hatches
 

You pretty much have installing hatches down :thumbup Use a saber saw or dremel or ?? to make a nice hole, deburr it a bit then use the gasket that it came with or marine Goop for a nice seal. I've used rivets at Malibu to install them, but then you need to make sure they expand all the way and are tight.
TC&TL,

PerryC. :coffee

Re: Installing Hatches
 

Perry, since you have access to the mounting hardware, you should try SS screws something like 3/16x .75. Using rivits may pull though the plastic. I use a dremel with a cutting wheel, than finish with a sanding drum. Always measure after every step. Seal with a good marine RTV

Tightlines
Steve