ACE Hardware DIY cart

[Fishyaker]

Originally Posted by gone_fishing

How did the final product work out? Were any modifications necessary?
Hank

Suprisingly, the final product works as I wanted with no modifications. I'm able to attach the cart using 2 18" bungy cords (one for each side crossing under the support and connected end to end through the scuppers).

Thing I might change if I were to do it again... using 2 more saddle clips instead of the tee fittings for the kayak support bars and 2 appropriate length PVs for the support bars themselves so that there is just one single bar instead of 2 shorter bars connected by the tee. The cart rolls fine on hard surface and is very stable (doesn't shift side to side or front/back).

[Piranha]

You were wise to revise. You've saved your yak! I think Hobie is the only yak that recommends a scupper cart! If I remember right, you have a cobra. You may wanna cut a pool noodle for cushion pads under the yak, but I suggest you give the ones you have a shakedown test. They might work just fine! I put my strap in the correct configuration on the cart skeleton, and attached it permanently to the cart in position using cable ties. You lean the cart at a 45 degree angle on the ground facing in the direction of the bow, place the yak on the cart,about 1/3 the distance forward from the stern, fasten the strap fairly snugly, then lift the back of the yak up quickly and the cart pops up into positiion. The cart will be in perfect position underneath the yak. No sweat! The bow will be on the ground and the stern in the air when you do this correctly. Finish retightening the strap in the upright position and you're ready to roll. If you ever go out with one of us, we'll demo it! Very simple and no crawling around on the sand under the yak! Piece o cake! Piranha out!
PS, I use the nylon strap with the spring loaded clamp. It's always on the cart and in exactly the right place! THis strap is tighter than Bungees!

[Fishyaker]

I'll grab a pic with the cart mounted when I get a chance. How you described the sitting of the yak on the cart is how mine appears :-) Trying to get the right angle for the scuppers on the cobra would have just been a nightmare. With this solution I was able to eyeball the details on my workbench and it fits like a glove.

[Piranha]

When you're haulin your yak back to the car, it's easier if you move anything heavy to directly over the wheels. That lightens the tongue weight you have to lift and puts the full moment of force on the ground! Pulling the yak that way is a piece of cake! Piranha